Action Points Page

The commands within this page set the default values for the properties assigned when they are created. Some of these commands define what TotalView will do when it encounters an action point. Other commands tell TotalView that it should automatically save information about action point to a file so the action points can be reloaded at a later time. In this way, you do not have to reset action points every time you start TotalView.

For additional information, see Action Point > Properties.

Default Action Point

The four controls in this area define the properties that TotalView assigns to action points when you create them.

When breakpoint hit, stop

Indicates what else is stopped when TotalView encounters a breakpoint. Your options are:

group: When one thread reaches the breakpoint, TotalView stops all processes in its program group.

process: Just stop the process that hit the breakpoint.

thread: Just stop the thread that hit the breakpoint.

When barrier hit, stop

Indicates what else is stopped when TotalView encounters a barrier breakpoint. Your options are:

group: When one thread reaches the barrier, TotalView stops all processes in its program group.

process: Just stop the process that hit the barrier.

thread: Just stop the thread that hit the barrier.

When barrier done, stop

Indicates what occurs when all threads or processes are stopped at the barrier breakpoint. Note that the set of threads and processes that are stopped at a barrier breakpoint is called the satisfaction set.

group: When a barrier is satisfied, TotalView stops all processes in the control group.

process: When a barrier is satisfied, TotalView stops the processes in the satisfaction set.

thread: Only the threads in the satisfaction set are stopped; other threads are not affected. For process barriers, there is no difference between process and thread.

In all cases, the satisfaction set is released when the barrier is satisfied.

Plant in share group

If set, enabling and disabling an action point alters it in all members of the share group. If this button is not selected, you must enable and disable the action point in each share group member individually.

Save action points file at exit

When set, TotalView automatically saves action points to an action points file when you exit. For more information, see the Action Point > Save All command.

Load action points file automatically

When set, TotalView automatically loads action points when it loads a file. For more information, see the Action Point > Load All command.

Open process window at breakpoint

If selected, TotalView opens or raises the Process Window when your program reaches a breakpoint. Unlike other preferences on this page, this preference changes how existing action points behave.